Details
Mixing Instructions: Measure out desired
amount of dry material. Put required amount
of water into mixing container first and then
add dry powder. To mix, use either a low
speed drill with paddle or pointer trowel.
Consistency should be similar to pancake
batter. Add about 19%-21% water per
kilogram of dry powder (4.54L per 22.7kg). Do
not re-temper mix by adding additional water
once product starts to set. This product is
formulated to take up to an additional 15lbs of
aggregate to enhance the look of your finished
project. Be sure to use dry aggregate as wet
sand will change your water requirement.
Application Procedure: Gently pour the mix
into the mould. Vibrate mould to help release
air bubbles. When pouring very thick projects
fill mould partially, vibrate briefly and then fill
balance of mould. When de-moulding the
finished product, handle gently and support
product evenly. The project can be demoulded in as little as 15-30 minutes
depending on mould size; a test project is
recommended to help familiarize you with the
product. Allow product to cure 3 hours before
active handling.
Color: Available in grey or white.
Limitations: Product should be poured into
mould within 2-3 minutes of mixing.
Temperature at time of application may not be
lower than 5°C/41°F. Set time will vary
depending on air temperature. Product can be
accelerated using warm water (40°C/104°F
max) and slowed using ice-cold water