Details
Mixing Instructions: Wear Rubber Gloves
• Measure 3.7 liters of clean water into a
mixing container.
• Slowly add PRS 60 powder to the water
and mix using a drill and mixing paddle.
• Final consistency of PRS 60 is a fluid putty.
Setting Time: Initial set: 26 minutes. Final set:
28 minutes.
Surface Preparation: Ensure all holes,
channels etc. are completely clean and free of
dust and any other laitance. Drill holes wide
enough to accept bolts with their washers. Drill
deeper holes than normally required if the
concrete is not sound. For added strength
“mushroom” the base of the hole by tilting the
drill back and forth while drilling the hole.
Totally clean out holes with a vacuum or
blower. Dampen concrete surfaces to ensure
a better bond.
Application: Place anchor bolts with washer
in the hole. Mix only enough material that can
be used in 5 to 10 minutes. Pour mixed PRS
60 into the hole and move the bolt up and
down a few times to eliminate air pockets. For
anchoring into channel applications, carefully
pour fluid Water grip along the channel and the
fixture until it is filled to the desired level. PRS
60 will set in 25 to 30 minutes depending on
ambient conditions. Do not attach bolts for 90
minutes. Allow more time for heavy machinery
installations.
Limitations: Temperature at the time of
application of this mortar may not be lower
than 5°C/41°F. In hot weather use cold water
to slow set up time. Do not mix more material
that can be used within 5 to 10 minutes.
Coverage: A 44 lbs pail yields approximately
.40 cubic feet. A 1” diameter hole requires
about 0.78 lbs of material per lineal foot. A
½” diameter hole requires about 0.2 lbs per
lineal foot.